PLC 2 1 Car Alarm Systems Car Key KB 26

1.Miss-touch 
Onc the vehicle started accidentally touching buttons that normally arm the alarm,will not arm the alarm,but will lock doors.Prcss disarm button to unlock the doors.

2.Vibration record 
If the car is bumpcd,the system will take a record about the vibration of the car and will give warning to the car owner by beeps when the alarm system is disarmed, so that the car owner can check the car inside and outside to make sure about the sagety of the car.

3.Warnings of improper closed of doors 
If the doors are not closed properly,the lamps will keep flashing for 15 seconds in order to give warnings to the car's behind.

4.Warnings of abnormal situation 
If the alarm system is triggered in arming mode,then:
(a) The siren will sound in arming mode (without sounding in silent mode) when the car window is knocked or when the car is bumped.
(b)The siren will keep sounding for 25+/-5 seconds when the car door is opened or when the engine is ignited illegally.

5.Hints for arming(Option) 
The alarm system will give signals to remind the car owner to arm the car after 10 seconds the car parks.
(a)The system will beep 4 times.
(b)The lights will flash 4 times.

6.Two Stage siren verification 
If the car body by bumped slightly,them L.E.D keep lighting and the parking light flash and the siren will only chirp 5 times.
If the car body by bumped continuously or the car door is opened,the siren will keep sounding for 25=/-5 seconds.

7.Memory alarm modes 
If the car power is cut off whelther the system is armed or disarmed, the system will still keep in condition when the power is connected again.

8.Trunk release function 


9.Transfer for the sound and siren. 
In any mode, press the lock botton for 5 seconds and then siren chirp once,it is ok for function transfer.

10.Setting the arm automatically 
When stop the car and close the door,the system will be int arming mode automatically 1 minute later.

11.Code learning mode 
In this mode ,the safty and reliability of the system are system are greatly increased for coding times over 1 million.
New code learning procedure:
(a)During disarming status,stay inside the car,close the door properly,then always on the foot brake, open the door (now the lamps flashing).
(b)Turn the ignition key from OFF-ON-OFF-ON-OFF-ON position 3 times,ank keep ON position(now the lamps keep lighting).Press any key of the remote control,the sirens will chirp 3 times after 3 seconds.indicating that a new code is stored. 
NOTE:All operating should be finished within 5 seconds, otherwise the system will cancel this learning Store another remote control code by repeating the same procedure.This system can be learnt up to 4 remote.

12.Remote control code cancellation 
IF the remote control is lost, it is necessary to cancel the remote control's code in the brain module for safely reason.
(a)during the disarming status,enter the car,keep the door closed,step always on the foot brake, then open the door.Now the lamps flash.
(b)Turn the ignition key from OFF-ON-OFF-ON-OFF-ON-OFF-ON-OFF-ON-OFF 5 times, and keep OFF position,Now the lamps keep lighting ,and the sirens chirp 3 times after 3seconds,indicating that all control's code is cleared from the system.